Search results for "electromagnetic [radiation]"

Prompt and delayed spectroscopy of 203At : Observation of a shears band and a 29/2+ isomeric state

2018

Using fusion-evaporation reactions, a gas-filled recoil separator, recoil-gating technique and recoil-isomer decay tagging technique we have extended the level scheme of 203 At ( N = 118 ) significantly. We have observed an isomeric [ τ = 14.1 ( 3 ) μ s ] state with a spin and parity of 29 / 2 + . The isomeric state is suggested to originate from the π ( h 9 / 2 ) ⊗ ∣ ∣ 202 Po ; 11 − ⟩ coupling, and it is depopulated through 286 keV E 2 and 366 keV E 3 transitions. In addition, we have observed a cascade of magnetic-dipole transitions which is suggested to be generated by the shears mechanism. peerReviewed

Decay studies of the long-lived states in Tl186

2020

Decay spectroscopy of the long-lived states in 186Tl has been performed at the ISOLDE Decay Station at ISOLDE, CERN. The α decay from the low-spin (2−) state in 186Tl was observed for the first time and a half-life of 3.4+0.5−0.4 s was determined. Based on the α-decay energy, the relative positions of the long-lived states were fixed, with the (2−) state as the ground state, the 7(+) state at 77(56) keV, and the 10(−) state at 451(56) keV. The level scheme of the internal decay of the 186Tl(10(−)) state [T1/2=3.40(9) s], which was known to decay solely through emission of 374-keV γ-ray transition, was extended and a lower limit for the β-decay branching bβ>5.9(3)% was determined. The extrac…

Level structure above the 17+ isomeric state in 152 69 Tm83

2018

Excited states above the 17+ isomeric state in the proton-rich nucleus 152Tm were established by employing the recoil-isomer tagging technique. Data were collected using the JUROGAM gamma-ray array and the GREAT spectrometer together with the recoil ion transport unit (RITU) gas-filled recoil separator and analyzed to identify the prompt and delayed γ decays from the levels in 152Tm. Shell-model calculations, either in a large valence space or in a reduced model space with five protons in the π0h11/2 orbital and one neutron in the ν1f7/2 orbital, agree with the observed energies of the yrast levels up to angular momentum J = 21. The observation of near degeneracies in the energy spectrum ca…

Lifetime Measurements of Excited States in $^{172}$Pt and the Variation of Quadrupole Transition Strength with Angular Momentum

2018

Lifetimes of the first excited 2 + and 4 + states in the extremely neutron-deficient nuclide 172 Pt have been measured for the first time using the recoil-distance Doppler shift and recoil-decay tagging techniques. An unusually low value of the ratio B ( E 2 : 4 + 1 → 2 + 1 ) / B ( E 2 : 2 + 1 → 0 + gs ) = 0.55 ( 19 ) was found, similar to a handful of other such anomalous cases observed in the entire Segré chart. The observation adds to a cluster of a few extremely neutron-deficient nuclides of the heavy transition metals with neutron numbers N ≈ 90 – 94 featuring the effect. No theoretical model calculations reported to date have been able to explain the anomalously low B ( E 2 : 4 + 1 → …

Experimental evidence on microwave induced electron losses from ECRIS plasma

2018

The balance between warm and hot (>1 keV) electron density and their losses from the magnetic confinement system of an Electron Cyclotron Resonance Ion Source (ECRIS) plasma is considered to be one of the main factors determining the rate of the high charge state ion production. One of the key loss channels for heated electrons is thought to be induced by the injected microwaves. While this loss mechanism, referred to as rf-induced pitch angle scattering, has been studied theoretically and with computational tools, direct experimental evidence of its significance in minimum-B ECRIS plasmas remains limited. In this work, experimental evidence of microwave induced electron losses in the axial…

Water detection in skin by dual-band photodiodes

2013

Purpose of this study was to develop a simple model for possibilities to detect water in skin by diffuse reflectance spectra. The model is based on comparison of diffuse reflectance spectra when illuminating water sample with LEDs of different wavelengths (1200 nm, and 1450 nm). The illumination LEDs were chosen due to water absorption differences in near-infrared spectral range. For detection, dual-band photodiode DSD2 by Thorlabs was used. Due to differences of water absorption at different wavelengths in the near-infrared spectral region, this correlation could be used for mapping of water content in skin or, in other words, determine relative moisture level in skin. Simple experimental …

Determination of chromophore distribution in skin by spectral imaging

2012

Possibilities to determine chromophore distribution in skin by spectral imaging were explored. Simple RGB sensor devices were used for image acquisition. Totally 200 images of 40 different bruises of 20 people were obtained in order to map chromophores bilirubin and haemoglobin. Possibilities to detect water in vitro and in vivo were estimated by using silicon photodetectors and narrow band LEDs. The results show that it is possible to obtain bilirubin and haemoglobin distribution maps and observe changes of chromophore parameter values over time by using a simple RGB imaging device. Water in vitro was detected by using differences in absorption at 450 nm and 950 nm, and 650 nm and 950 nm.

Absorption of drugs from the bladder and intravesical chemotherapy

1976

Model, software and database for line-mixing effects in the ν3 and ν4 bands of CH4 and tests using laboratory and planetary measurements-I: N2(and ai…

2006

International audience; Absorption spectra of the infrared ν3 and ν4 bands of CH4 perturbed by N2 over large ranges of pressure and temperature have been measured in the laboratory. A theoretical approach accounting for line mixing is proposed to (successfully) model these experiments. It is similar to that of Pieroni et al. [J Chem Phys 1999;110:7717–32] and is based on state-to-state rotational cross-sections calculated with a semi-classical approach and a few empirical parameters. The latter, which enable switching from the state space to the line space, are deduced from a fit of a single room temperature spectrum of the ν3 band at 50 atm. The comparisons between numerous measured and ca…

Design and Performance Evaluation of a High Power-Density EMI Filter for PWM Inverter-Fed Induction-Motor Drives

2016

This paper presents the design of an electromagnetic interference (EMI) filter for a low-voltage high-current induction-motor drives supplied by dc power grids. In order to effectively design the EMI filter, a suitable common-mode/differential-mode (CM/DM) separation technique has been used. Due to the high operating currents, the software-based separation technique using time-domain measurements has been applied. The proposed technique allows the CM and DM sections of the EMI filter to be properly selected in a more economical way, i.e., without the need of a dedicated hardware or costly radio frequency (RF) instrumentation. The design has been done according to a power-density criterion. …